Nest Thermostat Review, Update #7

Update #6, Update #5, Update #4, Update #3, Update #2, Update #1, Install

I received a replacement thermostat earlier this week as promised by Nest Labs. I had time this afternoon to do a swap and reinstall. Nest had asked me to swap the thermostats between two floors experimentally to determine whether a temperature reading issue was related to the location or the thermostat. It was the thermostat.

As part of the swap, I had to reprogram the two thermostats.

I’d swapped the defective thermostat with one from the basement. Apparently, the base has the S/N on it of the thermostat and they’re intended to be “paired” so I decided to return the thermostat to the basement and install the new thermostat on the first floor (replacing the original defective unit).

I removed the old unit and replaced the wires. Depending on the type of wires you’re using, you may find that it’s far more difficult to do than you would expect. I ‘d forgotten how much I hated trying to stick the very stiff HVAC wires into the thermostat’s base!

I replaced everything and activated the unit. You can look at the installation experience post for more information about the general setup.

Past the wifi connection, rebooting, waiting, waiting, waiting, then “ERROR.” “No Rc or Rh” connection.

20111218-IMG_0138

Crud. So, I popped the thermostat off the base and looked at the wires. They all appeared to be fine. So, I reseated the Rc connection and replaced the thermostat. Success! I find that a tiny tug on the wire after you believe it has been seated does the trick. The rest of the install went without issue.

The thermostat switched to the normal temperature display after a few more alerts. The only thing was – the temperature read 76F. Whaaaa? Given the reboot cycles, etc., I really hadn’t handled it much, not enough to cause the temperature to be that high. I waited about 5 minutes for it to start dropping and when it did not, I called Nest to speak with the person who’d handled the replacement, Mark. He was out apparently, so I ended up speaking with someone who went by “DK” for about 30 minutes about a few topics.

We decided the best course of action was to wait and see.

Thankfully, the new thermostat is now reading a temperature that I would expect, so for some reason, this new thermostat took quite a while to acclimate to the room temperature (much longer than the original three thermostats – around 45 minutes).

Nest Thermostat Review, Update #6

Update #5, Update #4, Update #3, Update #2, Update #1, Install

I didn’t expect to have another post so soon. But, the Nest experience continues to frustrate and baffle.

On the 3rd of January, I took the following screen shot of our basement schedule for heating:

image

Tonight (one day later on the 4th), we headed down to the basement to watch a recorded episode of AMCs Hell on Wheels and it was cold. Frak! What the…

The thermostat reported the temperature in the room was 62F. Seriously? It should have been about 66F at the time I looked.

I brought up the schedule and was disappointed (yet, not shocked given the other problems) to see:

image

All of the evening settings (except Monday?) had disappeared completely. I had not made the change. I don’t understand. I’m no artificial intelligence expert (my wife though has a CS Master’s degree with a specialty in it Smile), but I’m confident any learning algorithm I would write wouldn’t be this stupid and this broken.

If I were a competitor reading this, I’d be laughing just a little. Understand though – Nest still can make this work – don’t rest or expect them to just disappear so easily.

As Nest continues to be silent on these matters, I strongly recommend you not buy a Nest thermostat. It’s an undone expensive piece of hardware, that while shiny and new, isn’t ready for the duties it claims to have mastered.

Update: Janurary 13, 2012 – This happened again. The schedule for Saturday and Sunday was modified to entirely remove the evening set points.  Nest support recommended that I turn off the “learning” feature of the thermostat yesterday and I hadn’t done that yet. But now I will and see if it happens regardless.

Nest Thermostat Review, Update #5

Update #6, Update #5, Update #4, Update #3, Update #2, Update #1, Install

I got my replacement Nest thermostat today via FedEx.

I was surprised to open the box and find a complete sealed package. Honestly, I expected they’d ship just the display and the base (as the support engineer hadn’t set any expectations, I apparently just made up my own!). But, I suppose at this point in the company, they just aren’t setup to ship just the two pieces. It has the unfortunate side effect of producing extra waste (as I can’t imagine that extra wall plates are going to come in handy anywhere). The little screw driver could be given away but the rest likely will end up in a landfill. I’ll ship them all of the unused parts back as I don’t want them – hopefully they don’t just trash them.

There’ve been some really awesome commenters in the past few days and I wanted to take a moment to highlight a few key comments.

From Curt:

I finally called Nest and spoke to a pleasant fellow. First off, it turns out the Nest does NOT anticipate a temperature set point. It will not turn on the furnace ahead of time. If you train it to go from the night setting of 60 to the daytime setting of 68 by turning it to 68 when you get up, it will always be 60 when you get up.

Wow, that’s a super disappointment. Honestly, I really thought it could do that.

Another from Curt:

It does not keep as steady a temperature as the primitive Honeywell round thermostat it replaced.

From Mark:

I’ve had my Nest for about 10 days. I would recommend waiting before buying one.

Kevin:

I’ve been considering replacing my Honeywell programmable t’stat with a Nest…but now I’m not so sure

David shares my disappointment regarding Nest Labs:

I would love to hear what NEST has to say about the variances…I would think they are monitoring these blogs…..If they are not…shame on them.

They seem to be way too quiet. They don’t seem to “get” social media.

And Matt provided a link to a very complete tear-down of the device:

Here is a good site that did a tear-down,lots of comments and people look like they really know what there talking about!

http://www.sparkfun.com/tutorials/334

GregN is still enthused about his Nest thermostat:

You guys are right in all the above posts. But to be honest, I’m happy with setting a schedule that warms the house before I get up in the morning, and saves energy overnight. Yes, I had that functionality at a lower price point before the Nest. But I didn’t have remote adjustments or the great looking hockey puck on my wall before.

Thanks again for all the comments! Keep them coming!image

I won’t replace the poorly functioning Nest thermostat for a few days with the new unit (as it’s a nuisance to adjust all of the schedules, move the units around, etc.).

Today, the system had again auto activated the “away” mode apparently, and then did not activate the normal evening schedule. So, our house was cold when we returned from work, even though it should have been warming for about a half hour. I just don’t understand this feature. I don’t understand why “away” isn’t triggered at night.

I could turn off learning, auto-away … leaving me with remote scheduling.

Update: January 11, 2012 => Something triggered the “auto-away” feature two days in a row now. I don’t understand why it happens. The part that’s annoying is that the schedule doesn’t run when this happens apparently, so we came home to a cold house (and tonight I thought to check before leaving from work to see if it had happened again).

Nest Thermostat Review, Update #4

Update #6, Update #5, Update #4, Update #3, Update #2, Update #1, Install

A bit more about my Nest thermostat experiences.

On the weekend, I spoke with a support engineer from Nest regarding the issue I was having with one of the Nest units failing to properly read the room temperature. I swapped one of the thermostats with a thermostat from a different floor in our house and then monitored the results over the weekend. I noticed the same problem in the new location: the thermostat would regularly read a temperature that was 3 to 4 degrees warmer than the actual room temperature. As it doesn’t consistently exhibit the problem, it makes heating a room to a comfortable temperature somewhat challenging (and now that it’s 19F outside, I’d like it if it was a bit more on the mark).

I spoke again with the same support engineer from Nest today (Mark). He called back as promised at the telephone number I left with him. He agreed that it was the thermostat that had a problem and decided to ship me a new one immediately (overnight). As today was an “observed” holiday for most shipping companies in the USA, the new thermostat won’t ship till tomorrow.

Interesting tidbit is that the base of the device apparently has a serial number that is tied to the display and that they both must be returned at the same time when shipping a defective unit back to Nest.

20111218-IMG_0136

When I arrived home this evening, my wife and I did our normal patterns. Go here, drop stuff off, etc. One of the places my wife walks nearly every evening takes her right by the Nest thermostat in a hallway on our first floor.

As we were sitting down for dinner about 30 minutes later I noted that the temperature seemed a bit cooler than normal in the kitchen so I walked over to the thermostat. “Auto away” had been activated. Arrgh. What’s odd (and annoying) is that the temperature should have been going to 69F starting at 5pm. At some point, it had decided that we were “away” and had never arrived home (I checked all of the schedules and everything seemed normal). I thought that there was some way to review the timings and choices it makes for that setting, but the “Energy” option on the thermostat reported “No data” for any of the recent days (I would have expected at least one day as I had moved the thermostat two days earlier).

UPDATE: Jan, 4, 2012: Ok the above happened AGAIN. I don’t know why I’d want AUTO AWAY to also DEACTIVATE the schedule? Seriously? Turn off learning. Turn off Auto-away. What’s left Nest?

So, I don’t know what to make of this new “feature.” Clearly, we were in the house and the auto away should have been deactivated by our presence (I thought?). We did not activate “away” mode manually either.

image

I definitely can’t give high marks to this product and wouldn’t recommend it right now. I know others are apparently having decent success, but until the kinks are worked out or they do a lot more explaining, I’d recommend anyone thinking about buying one to wait (maybe for v2 or a significant software upgrade).

If anyone from Nest is listening, please speak up!

(And anyone else with comments, questions, etc., feel free to leave them! I enjoy your comments and feedback and I know others are finding your comments very useful!)

I’ve created a new home for discussions about digital thermostats. Here’s a bit more information and here’s the site (digtstat.com). (And thanks for your help in getting it started!)

Nest Thermostat Review, Update #2

I’ve discussed my Nest thermostat experience a few times and am slowly becoming less convinced that it is ready for the market if you’re at all technically savvy and you’re easily frustrated by things not working the way you’d expect (like, you know how to setup e-mail on your phone).

Update #6Update #5Update #4Update #3Update #2Update #1Install

Here’s a image of the schedule for the second floor, where my computer/den is located.

image

image

On Monday and Tuesday of this week, my wife and I had the day off and were home most of the day. We spent a lot of time upstairs as her computer and crafting area is on the second floor, as is my den. So, the heat was turned up most of the day.

The “learning” mode of the thermostat decided that as we were home two days in a row, that the whole week likely was going to look like that apparently. As you can see, the same schedule was replicated through all week days. image

On a normal morning, I often go to my den and do a bit of tinkering before leaving for work. However, I rarely turn up the thermostat and instead just leave it at the preset temperature. I’m not in my den long enough to justify the amount of energy it would take to heat the second floor.

So, it’s frustrating that the thermostat would turn up the heat automatically at 9:30am, long after I’ve left for work and then run it all day long. Thankfully, after 3 hours, it apparently realizes there’s no one home, and will automatically adjust the temperature.

Since I didn’t turn the heat UP, I don’t expect to need to turn it DOWN before I leave (I leave earlier than 9:30am). (Turn it down from what?)

I could turn off the learning features. But, then one of the key features of the thermostat is turned off:

image

GregN left a comment yesterday where he mentioned that Nest support recommended to try turning of the learning feature (activating “learning pause”).

Now, I need to go fix the schedule to reflect my reality. Again.

Nest, are you listening? This is a perfect example of my user experience not matching with the expectations Nest has set.

Update (December 30, 2011)

I tweeted this post (and directed it at nest and they did respond):

image

Update (December 31, 2011)

My wife had the day off on Friday (Dec 30) and adjusted the downstairs thermostat after lunch. Apparently, the thermostat believes that’s going to be a new routine for Friday’s (at about 1:30pm, temperature is set to 68F).

Just the day before I’d fixed the schedule for every day. It’s not taking into account manual schedule changes and giving them proper weighting.

image

The learning algorithm needs some help.