Comments on: Blue Iris 3 and Samsung SmartCam SNH-1011N

By: Aaron

Aaron — Mon, 26 May 2014 14:13:56 +0000

In reply to Allison Rose. OK? "Every camera model?" I'm extremely skeptical.

By: Allison Rose

Allison Rose — Mon, 26 May 2014 11:35:48 +0000

I use IP Camera Viewer with the Y-Cam cameras. It has a built in profile for every camera model

By: Aaron

Aaron — Thu, 13 Mar 2014 00:38:31 +0000

In reply to Jon. Excellent question -- I thought I'd mentioned it ... I looked at the network traffic using a tool called Wireshark. That may have been unnecessarily complex, but I knew how to use it. :)

By: Jon

Jon — Thu, 13 Mar 2014 00:36:37 +0000

How did you figure out what the video path was in the first place? Is there a list of variables that can be used?

By: Aaron

Aaron — Thu, 13 Mar 2014 00:32:37 +0000

In reply to Jon. Odd, I don't have an unreasonable delay in the first place in my setup. However, thanks for the tip as it might help someone else! :)

By: Jon

Jon — Wed, 12 Mar 2014 19:15:52 +0000

I played around with the setting and now have it down to about 1-2 sec delay using the video path of “/profile2/media.smp”. I tried using “profile1” instead but ended up with most of the screen green with just the top viewable. 2 seems to be the magic number with minimal delay.

By: Jon

Jon — Wed, 12 Mar 2014 18:52:56 +0000

I’m getting 10-12 secs delays using this setup compared to only 1-2 secs when viewing through the SmartCam app. Any ideas why this feed method is so slow? People are at my front door or in my garage for more than 10 secs before I even see them. Many times already gone before I know they were there in the first place.